The Commodore Club of Tasmania Forums: PWR 051 - Viewing Profile

#############MAKE AN OFFER#############



Having a clear out in the shed
few bits and pieces to sell .all prices are negotiable

Genie VN/VP/VQ/VG 3.8litre v6 extractors $150
Commodore extractors (used) V8 304 injected 5litre vn-vt $100
Radiator to suit V6 Manual $110
VY-VZ front strut brace $50
V8 Radiator $50
X2 V8 finned calipers $50
VN/VP/VQ/VG aircondioning pump $30
X2 290mm V8 vented rotors $50
Dash controls next to instrument cluster.trip computer and cruise control,headlights etc etc...$60
VN,VP,VG,VQ series 3 instrument cluster with 3 bar digital LCD trip computer screens $100
VN V6 wiring loom modified to run level 3 dash and trip computer $100
VQ Caprice leather seats 2 electric fronts and rear seat $150
T700 V8 4 speed Auto gearbox,electric overdrive $200


Also wrecking a 1992 VQ Statesman Caprice..so got lots of small bits and pieces laying around

I will seperate parts also.so contact me if interested
I dont get on here alot so if your really interested,your best to txt or call me on 00457096265
All parts are located in turners beach,near devonport
Please call to organise a time and not just turn up and stalk out turners beach until you find my house and demand the parts like some people think its okay to do....

i've just converted my 308 into a efi 304 in a vn and am stuck to as where the heater hoses and heater tap run.does anyone have some pics or a diagram of this?
any help would be appreciated

I am in the process of stripping all the v6 gear out of my vn to put a 304 in it..the whole lot is up for sale

3.8 Litre series 1 Buick manual motor.has done just over 100,000km
Has series 2 fuel rails injectors and modified regulator off a VR BT1
Port matched and cleaned up for better flow intake manifold
All new Spark plugs,welch plugs,seals and gaskets..the only thing i didnt do to it was put new bearings or rings or pistons in it..
New water pump...has cast rocker covers(the flash looking after market ones) with a breather pod filter on it.
VT coil pack,hot earth set up
Computer with custom HSV SV3800 Memcal
Looking at around $300


Near new Genie extrators with the Y-two into one piece $200

V6 Radiator with new tanks and cores professionally flushed $150

3" stainless steel intake pipe(pretty much a bolt on replacement for standard pipe) $70

Machined Flywheel and new clutch and throw out bearing $100



I will seperate parts also.so contact me if interested
I dont get on here alot so if your really interested,your best to txt or call me on 0447710899
All parts are located in turners beach,near devonport

hey i have a set of heads for a 308 off a SS LX hatch back $180

redline maxitork manifold in good condition to suit 253/308 and 4 barrel carby $270

Rochester quadrajet off a LH SLR5000 $100

i dont get on here alot so if your really interested its better to send me a txt or call 0447710899

Hey
i am chasing a set of heads for a 304..pre vt if possible

0447710899