[motors405]

I'm sure someone can answer this strait away!!!

After the manual conversion i no longer have the spare hole to run my amp power lead through the firewall (clutch cable).

All i'm asking is. Where on the RH side of the car is it best to run the wire? I saw Suttons install progress pics and saw that it was running from near the fuse box.

[xlr8ta]

From memory I ran mine through the grommet that the bonnet release cable ran through, was either that or the accelerator cable one, just trimmed a slight split in the grommet and pulled the cable through

[HR1966]

I ran mine through the clutch one because I was lazy. The bonnet release hole sounds the goods. Provided it is big enough for you cable size.

I would lay on your back under the dash and look for all the peptrations through the firewall and see if you can get your cable through there. Then check where it comes out on the engine bay side.

If you have troubles pushing the cable through the grommet just spray some CRC on it and it'll slide through easier than a sausage up a...well you get the idea

[Murph]

HR1966, on Feb 8 2007, 07:07 AM, said:

through easier than a sausage up a...well you get the idea

Hallway???

[HR1966]

Murph, on Feb 8 2007, 09:15 AM, said:

Hallway???

Ummm... Hallway... yeah, that's it...

This post has been edited by HR1966: 08 February 2007 - 08:35 AM

[motors405]

hahaha. After further investigation i'd found that a hole had been drilled next to the accelerator cable??? looked fresh. All i gotta do is get a drill in there to make it bigger. But i'll also look for this bonnet release as well.

This post has been edited by motors405: 15 February 2007 - 09:47 PM

[motors405]

All done now. So good to have it all going again!!

[Prewer]

Pics or ban

[V8RMBL]

Murph, on Feb 8 2007, 09:15 AM, said:

Hallway???

HR1966, on Feb 8 2007, 09:35 AM, said:

Ummm... Hallway... yeah, that's it...

That cracks me up every time...


Damn that was a huuuuuuggggeeee night.